CNC carpenter carving machine as a fully automatic high-tech mechanical equipment, the operation must be in accordance with the process. These requirements and operating procedures will have specific instructions for us to refer to before each device is shipped from the factory. Therefore, customers must read the relevant materials supplied by the Carpenter Carving Machine Factory. In addition, when our technicians go to the customer for on-site training, they will also operate it in detail and introduce the dark operation process.
1. It is necessary to check and acknowledge whether the cooling system (pump) and smooth system (oil pump) of the motor are working properly before and during the carving process.
2. Do not touch the hand when the spindle rotates to avoid accidental damage.
3. Pay attention to the debris in the sports box to ensure the normal operation of the machine.
4. When clamping the workpiece, it is necessary to follow the principle of “installation, flattening, and loading”. It is forbidden to sculpt the suspended data; in order to avoid the deformation of the data, the thickness of the data is more than 2mm larger than the depth of the carving.
5. The debris in the chuck must be cleaned before loading the tool.
6. When the tool is loaded, it must be screwed into the lock nut first, put it on the motor shaft, then prick the tool into the chuck, then slowly lock the nut with the upper wrench, and load and unload the tool. When the elastic nut disables the push-pull method, the rotation method is used.
7. The length of the tool to expose the chuck must be determined according to the depth of the carving, whether the workpiece and the fixture interfere, and try to take short when satisfied.
8. It is forbidden to listen to any items on the beams and baffles of the carpenter's machine tool to avoid falling and hurting people.
9. It is forbidden to lie on the machine during the operation, and it is not allowed to sit or lean on the machine frame.
10. Before processing, it is necessary to correctly define the starting point of the X, Y, and Z axes. After replacing the tool, it is necessary to immediately re-define the Z-axis starting point. The X and Y-axis starting points cannot be changed.
11. Use the tool to define the tool point to prohibit the spindle from rotating, so as to prevent the tool from being smashed; it is forbidden to fill the tool and fill the oil. If not, the cup should be covered with a cup.
12. Before starting the machining (below the knife), you must put your hand on the red button of the emergency switch, and press it when there is an unexpected situation.
13. It is forbidden to hit the chuck with a wrench when unloading the knife.
14, students must be diligent in the operation of the machine, brain, the use of all kinds of carving supplies must pay attention to save, not ruin.
15. At the end of the process, the machine tool power supply should be closed, the workpiece should be sent for inspection, the pick-up work, the measuring tool, the cleaning machine and the ground, and the “instrument and equipment operation record” should be carefully filled out.
In order to avoid damage to the equipment and personal injury, the carpenter carving machine operator must operate in accordance with the above requirements, and do not operate at will.
